Measurement methods of main parameters of solid-state lasers

This standard was drafted in accordance with the rules given in GB/T1.1-2009.

This standard replaces GB/T15175-1994 "Test Methods for Main Parameters of Solid-State Lasers".

Compared with GB/T15175-1994, the main changes of this standard are as follows:

--- Chapter 3 refers to GB/T15313, and deletes the same terms and definitions in the original standard as GB/T15313;

--- Chapter 4 has added the "Arbitration Measurement of Standard Atmospheric Conditions" provisions;

--- Deleted the "transverse mode" measurement method in the original standard (see 5.3 in the 1994 edition);

———The measurement of "hollow probe method" is added to the measurement method of "beam width or beam diameter" (see 5.7);

--- Increase the measurement method of "beam quality" (see 5.9);

---Specify the specific content of the "degree of polarization" measurement method, and delete the original standard's reference to GB/T7257 "Helium Neon Laser Parameter Test Method" (see 5.11);

———Appendix A, Appendix B and Appendix C have been added.

This standard was proposed by the Ministry of Industry and Information Technology of the People's Republic of China.

This standard is under the jurisdiction of the China Electronics Standardization Institute.

This standard was drafted: China Electronics Standardization Institute.

The main drafters of this standard: Zhang Peng, Chen Lan.

The previous versions of the standard replaced by this standard are as follows: --- GB/T15175-1994.